• Using these gases it may be possible to cross-calibrate sensors for other gases and using a beakers of different volumes rating. It is possible of to Calibration at different ranges than the concentration mentioned on the Ampule.
• Before use, it is important that both the ampoules and the calibration beaker are clean and dry. Ampoules should not be used if the glass is cracked or fractured and the calibration beaker should not be used unless the lid is tight fitting.
• Because some gases (e.g. Cl2) are easily absorbed it is recommended that the internal surfaces of the calibration beaker Be permeated with the calibration gas prior to actual calibration.
• This is most easily accomplished by placing an ampoule in the beaker, placing the beaker over the sensor and breaking the ampoule as if performing a normal calibration routine. The ampoule should be left in place for approximately 5 minutes.

Calibration-Ampoules Finds applications in wide variety of industries where Detection and control of dust level is critical for the safety, Maintenance , Equipment operation, Plant Efficiency and or the environment.

It provides Reliable and Economical Detection of leak and filter Failures in Powder and Bulk Solids industries Stack guard has LED visual Indication and relay output to maximize its user-friendliness and automation capabilities.

It incorporates a specially designed adjustable damping system that increases its response time and prevents False alarms

• Using these gases it may be possible to cross-calibrate sensors for other gases and using a beakers of different volumes rating. It is possible of to Calibration at different ranges than the concentration mentioned on the Ampule.
• Before use, it is important that both the ampoules and the calibration beaker are clean and dry. Ampoules should not be used if the glass is cracked or fractured and the calibration beaker should not be used unless the lid is tight fitting.
• Because some gases (e.g. Cl2) are easily absorbed it is recommended that the internal surfaces of the calibration beaker Be permeated with the calibration gas prior to actual calibration.
• This is most easily accomplished by placing an ampoule in the beaker, placing the beaker over the sensor and breaking the ampoule as if performing a normal calibration routine. The ampoule should be left in place for approximately 5 minutes.

Calibration-Ampoules Finds applications in wide variety of industries where Detection and control of dust level is critical for the safety, Maintenance , Equipment operation, Plant Efficiency and or the environment.

It provides Reliable and Economical Detection of leak and filter Failures in Powder and Bulk Solids industries Stack guard has LED visual Indication and relay output to maximize its user-friendliness and automation capabilities.

It incorporates a specially designed adjustable damping system that increases its response time and prevents False alarms