English Manual Needle RF Machine

Listing ID #5222697

Before Transportation

• The distilled water should be cleared before transportation.
• Open the distilled water discharge valve[5] as the picture shows (turning it to the counter
• clockwise and the pull out the stopper), discharge the distilled water, move the machine to
• help the distilled water get out completely.

Notice

• While discharging the distilled water, the Cool & Heat work hand-rod should be placed at
• the handle support.

Steps of Add Distilled Water

• Use distilled water or deionized water;
• Make sure the distilled water discharge valve[5] is closed;
• Use special funnel to connect to distilled water inlet[3];
• Add distilled water or deionized water from the funnel;
• Add liquid until the level of the distilled water level window[7] arrive at 4.5;
• Add cooling fluid successfully first time;
• Connect power supply line[9], turn on general power switch[8]. Input password “000000" to
• enter interface as (Fig 1) shows, click on “Set” to enter interface as (Fig 2) shown. Click on
• “Liquid setting" to enter interface as (Fig 3) shows, click on "Start" to become counter down.
• When stopped, please observe the status of distilled water level window, if it doesn't arrive at
• level 4.5, please add cooling fluid again until the level is above 4.5 ,then take off the funnel.

Note

• Add about 1L distilled water or deionized, change the water after one week.
• When could not add into the distilled water, please open the distilled water discharge
• valve[5], Add the distilled water and observe the valve. when the liquid is smooth
• outflow, blocked it and continue to fill...
• If do not use the apparatus 15 days or above, we are recommended to put the distilled
• water clean and clear.