Our Products
Transformers
2 Products availableSensors
2 Products availableMagnetic Switch
1 Products availableLevel Switches
1 Products availableElectric Fittings And Components
1 Products availableProximity Switches
1 Products availableLaboratory Apparatus
1 Products availableOur Complete range of products are Off Line UPS, Offline Power UPS and Online Power UPS.
Specifications
Capacity | 500 VA to 4 KVA |
---|---|
Input | Voltage : 170 - 270V Single Phase Frequency : 50Hz +/- 1% Rectifier : Automatic float cum boost charger, CVCC type. |
Out Put | Voltage : 230 V + 3% with AVR Frequency : 50Hz + 2% Wave from : Sine Wave (with AVR) Inverter Step approximate sine wave |
Back up Time Options | 15 min. -10 Hrs. with External Battery |
Recharge Time | 6 to 8 hours for 90% charge |
Indications | Mains ON-(Glowing) i.e. UPS on mains UPS ON ( Blinking) - Every 5 sec with Buzzer - UPS on battery backup - Every 5 sec with Buzzer - 75% of backup power utilized initiate save & quit operations Fault (Glowing) - System trip due to Over Load / Battery Low / Short / No Load Cut Off |
Control Method | MOSFET based constant Voltage Current Limit |
Transfer Time | <4 Milliseconds |
Environmental | Temperature : 0 to 40oC Humidity : Ambient 30 to 90% |
Protections | Built in AVR gives regulated output against fluctuation Fuse for over load & short circuit protection Noise & spikes gets eliminated by EMI / RFI filter Battery Low, Over & Under Voltage Protection. |
Indications | Mains : On, Over voltage, Under Voltage, Failure Battery : Charging, Low Inverter : On, Output high, Output low, Output over load trip |
Meters | Voltmeter to read input & output |
Controls | Mains : MCB Load : MCB ( Optional ) Inverter : DPDT |
Static Bypass : ( Optional ) | Adequately rated solid state switch which will transfer load from UPS to Mains within 10 Mesc. (synchronized ) 20 Msec. (unsynchronized) to avoid any damage to loads. |
Specifications
Capacity | 500 VA to 50 KVA |
---|---|
Input Requirement | Voltage : 230 V Single Phase + 19% - 15% or 415 V Three Phase +/- 15% Frequency : 50Hz +/- 6% Rectifier : Automatic float cum boost charger, CVCC type. |
Out Put performance | Voltage : 230 V Single Phase + 1% or 400 V Three +/- 1% Frequency : 50Hz +/- 0.5Hz Wave from : Sine Wave |
Distortion | THD less than 5% with no single harmonic greater than % on linear load, Power Factor : 0.8 lagging to unity. |
Inverter Side | Inverter Efficiency : On full load better than 85% Control method : Sinusoidal PWM control Circuit Method : True on Line PWM UPS Zero Transfer Time |
Normal DC Voltage | 48 V DC / 60 V DC / 120 V DC 144 V DC / 240 V DC / 300 V DC Creast Factor : Better then 2.5 |
Transient Response | For step load change from 25 to 100% output voltage will remain within 10% and recovers to 2% within 60 msecs. |
Environmental | Cooling : Forced air cooled. Temperature : 0-50oC Ambient Humidity : 95% RH non condensing Acoustic Noise : Less than 60db at 2mts. from the cubicle. |
Protections | Input - Mains over voltage / under voltage |
Output | Output over voltage Output under voltage Output over current |
Battery | Battery over voltage Battery low Battery over current |
Alarms | Mains failure Battery reverse polarity (Optional) Battery low |
Indications | Mains : On, Over voltage, Under Voltage, Failure Battery : Charging, Low Inverter : On, Output high, Output low, Output over load trip |
Meters | Voltmeter to read input & output |
Controls | Mains : MCB Load : MCB ( Optional ) Inverter : DPDT |
Static Bypass : ( Optional ) | Adequately rated solid state switch which will transfer load from UPS to Mains within 10 Mesc. (synchronized ) 20 Msec. (unsynchronized) to avoid any damage to loads. |