POWERMASTER LTD.

Turbhe, Navi Mumbai, Maharashtra

The design of these tube cutters are such that they cut ferrous and non - ferrous tubes quickly and effortlessly. A constant feed rate of the cutting bit is achieved by combining high torque motors with our lever assist unit. It results in higher productivity and an extended life of the cutter.

We also offer similar machines for tube facing and seal weld removal tools.

• Fast tool change from one diameter tool to another.
• Tool bit is easily changed without disassembling the tool.
• Lightweight and durable.

• POWERMASTER Push Type Internal Tube Cutters quickly cuts through the walls of ferrous tubes in Condensers and Heat Exchangers as a step in their removal from the tube sheet.
• This sturdy Push Type Internal Tube Cutters can be used with a portable Electric or Air Drill Motor.
• Push Type Cutters are simple to operate. Merely insert it into the tube, apply power, press inward and the tube can be cut in a few seconds. Releasing of inward pressure automatically retracts the Cutter Bit. These Tube Cutters are equipped with an adjustable collar suitable for reaching into tubes at various depths.
• The replaceable cutting bit can be interchanged in a few seconds. Standard adjustable reach is 4(101.6mm) and they are available in optional increments of 2(50.8mm). A reach = 6(152.4mm). B reach = 8(203.2mm). C reach = 10(254.0mm) etc.
• All Tube Cutters come with a complete set of pilots covering the entire range of tube thickness for a particular tube O.D. (ATP-625 tube cutters come with a built in pilot suitable for one tube ID only.)All Tube Cutters are available for MM tube sizes also. Please enquire.

• POWERMASTER One Revolution Internal Tube Cutter pierces and cuts off non-ferrous and thin walled ferrous tubes in one revolution.
• This One Revolution Internal Tube Cutter is designed for hand operation using a ratchet handle.
• The Cutter Tool Bit operates on an eccentric principle. The Tube Cutter is entered in the tube with the Tool Bit in closed position , ratchet is applied and turned in clockwise direction. The Tool Bit contacts the tube during the One Revolution and pierces the tube wall and as turning is continued the Tool Bit shears through the tube along its circumference. This Cutter is fitted with an adjustable collar enabling it to reach into tubes at various distances and they are available in optional increments of 2(50.8mm). Standard adjustable reach is 6(152.4mm).A reach = 8(203.2). B reach = 10(254.0mm). C reach = 12(304.8mm) etc.
• All Cutters are available for MM tube sizes also.

These tools are similar in operation to the Stiff Arm Winged Tools, but patented Cone Cutters are attached onto flexible arms. These tools are used in typically very large vertical pipes and are used in tube cleaning pipes from top to bottom.