Our Products
Refrigeration Parts
2 Products availableSensors
2 Products availableFlow Switches
1 Products availablePressure Switches
1 Products availablePhysiotherapy Products & Equipment
1 Products availablePhysiotherapy Equipment
1 Products availableMobile Communication Services
1 Products availableWe offer a complete product range of Tru-Pull Lite, Intelect Advanced Combo, INTELECT MOBILE COMBO and INTELECT MOBILE ULTRASOUND
Indications
The Tru-Pull Lite incorporates a patented technology of independent pull straps, which apply a true and consistent pull on the patella during flexion and extension, thereby realigning the patella. The Tru-Pull Lite is DonJoys most comfortable, low profile and shortest patellofemoral brace, yet strong enough to relieve pain. Recommended for acute mild to moderate anterior knee pain, support for patella instability, lateral subluxation and maltracking.
Features and Benefits
Measurements taken 15 cm (6") above mid-patella
Size |
CM |
INCH |
XS |
33-39 |
13-15.5” |
Small |
39-47 |
15.5-18.5” |
Medium |
47-53 |
18.5-21” |
Large |
53-60 |
21-23.5” |
XL |
60-67 |
23.5-26.5” |
XXL |
67-75 |
26.5-29.5” |
The paddle type SPDT WFS series are designed to provide excellent performance where accuracy, reliability, and rugged construction are required used in liquid flow lines carrying water or any fluid neither
harmful to brass and prosphor bronze nor classified as a hazardous fluids.
They can be wired to close one circuit and open a second circuit when liquid flow either exceeds or drops below the adjusted flow rate.The WFS series are recommended for liquid pressure and temperature
as mentioned below and must not be used on lines carrying liquids below 0 C.
These series may be used on liquids with high salt or chlorine content but is not for use in hazardous atmospheres.They may be also used outdoors but must be protected from weather or splashing water.
All series WFS flow switches are designed for use only as operating controls.
Where an operating control failure would result in personal injury and/or loss of property, it is the responsibility of user to add safety devices that protect against, or supervisory systems that warn of control failure.
PI (proportional plus integral) control action provides accurate, stable and comfortable temperature control.
Compatible with series 70 direct-coupled damper / valve actuator like ML7161, ML7174, ML7420 / ML7421series ML7425, ML7984 series, N20010, S10010, M7410E series, CN7505, CN7510 / CN72 seriesCN7220 & CN7234 also VC79 series etc.
Backlit LCD to display both setting and measured value.
Adjustable Zero Energy Band, On/Off
Differential, Proportional Band and Temperature Offset.
Analog output can be forced manually to be convenient for installation & commissioning.
Optional 2 to 10Vdc or 4 to 20mA direct acting and reverse acting analog output.
Selectable internal and external temperature sensor.
Wide temperature control range (-20 to 110C by using external temperature sensor) is suitable for extreme temperature control such as steam and ice water.
Watch Dog Timer: to resume the controller from hanging condition.
Brownout effect to avoid malfunctioning and care on power ON and power OFF.
Pluggable terminal block allows pre-wiring outside of the controller.
Compact size and slim design provide elegant and attractive modern style appearance.
Application
H7080B series duct mounting humidity and temperature transducers are designed for environmental monitoring and control applications in industrial, commercial and general building. These sensors can be used for discharge, outside or return air control.
Features
Temperature Output: NTC or Pt1000
420mA/ 010VDC or resistance output for temperature
420mA/ 010VDC output for humidity
Duct mounted
Excellent linearity
Good long term Stability
High reliability
Wide sensing range
Easy installation
FEATURES:
Converts airspeed into a 4 20mA or a 0 10 VDC signal
Linear output signal
Made with corrosion resistant material
Fully electronic registration of airflow speed
AC or DC voltage supply
Compensates for changes of air temperature
Telescopic sensor facilitates installation
Temperature output signal 0 10 VDC
Fuse protected
APPLICATION:
The ESF-35-2 airflow transducer can be used in a wide range of applications such as:
- Measurements of airflow speed via PLC/outstation/EMS
- Regulation of airflow speed
- Monitoring of airflow speed
Applications
Differential pressure switch e.g. for monitoring filter, fan, fire damper or air flow status of air handling systems.
Benefits
Switching point easily adjustable with scale in Pascal
Direction of PG 11 conduit entry rotatable in steps of120
Only one screw needed for housing cover
Pressure medium
Air, non-inflammable and non-aggressive gases
Modern appearance
Large, blue backlit, LCD screen
Eco button for energy saving
RS485 interface (Modbus protocol)
Button lockout function avoids unauthorized operation
Non-volatile memory (EEPROM) retains user setting during power loss
Low temperature protection
Standard dimension 86x86mm box for installation
Temperature sensors are provided with failure alarm function to facilitate maintenance
Features:
Features:
Features:
Features:
Features: