Verified
Write a Review
Our Products
Level Transmitters
2 Products availableLaboratory Equipments
1 Products availableGas Analyzers
1 Products availableProcess Control Systems & Equipment
1 Products availableTransducer
1 Products availableOur product range contains a wide range of Dissolved Oxygen Sensor, ph sensors, Ultrasonic Level Sensor, Sensors and Oxygen Sensor
this series of steam sterilizable electrodes are designed for economical use. They are constructed very similar to the standard ph electrodes, have a 10 and 12mm body, and can be ordered with the desired length. Length is determined by the insertion depth on the under side of the fermentor head plate to the tip of the probe. Glass disposable electrodes are available in galvanic styles to fill all requirements. The glass do probes are available for laboratory fermentation, where sterilization takes place in a separate autoclave. The disposable dissolved oxygen electrodes are compatible with most common oxygen amplifiers. Glass body oxygen electrodes are non temperature compensated and are required to be kept at a constant temperature. Calibration must be made at the same temperature as the controlled fermentation. The electrodes feature external filling tubes. Electrolyte can be added during use without removing the electrode from the vessel. The electrode membranes can be replaced very easily. However, some skill is involved in replacing them.
| specification | ||
| type | : | galvanic |
| cathode | : | ag |
| anode | : | pb |
| body | : | glass |
| diameter | : | 10mm |
| response | : | 98% in 90 seconds |
| temperature compensation | : | no. |
| temperature : range | : | 0 to 60c |
| sterilization temp | : | 130c |
| residual signal | : | 0.5 1 mv |
| output (medium saturated with air) | : | 40 mv 5 mv |
| Specification | ||
| Range | : | 014 pH |
| Body | : | Epoxy with Glass Bulb |
| Type | : | Combination |
| Sensor Output | : | mV |
| Pressure | : | 5 Bar |
| Temperature | : | 080C |
| Junction | : | Double Junction Ceramic |
| Process Connection | : | & BSP Male |
| Mounting | : | Pipeline mounting |
| Cable Length | : | 5 Meter with BNC connector |
pH Electrode Sensor MS pH 07
| Specification | ||
| Range | : | 0 to 14pH |
| Body | : | Glass |
| Type | : | Combination |
| Sensor Output | : | mV ( 59.4 mV/pH change at 25C) |
| Pressure | : | 2 Bar |
| Temperature | : | 0100C |
| Junction | : | Ceramic |
| Cable Length | : | 1 Meter with BNC connector |
Industrial pH Sensor - Flat MS pH 36 (Origin : USA)
| Specification | ||
| Range | : | 014 pH |
| Body | : | Ryton |
| Pressure | : | 7 Bar |
| Temperature | : | 0 110C |
| Temperature Compensation | : | Pt-100 Built-in |
| Junction | : | Double Junction Teflon |
| Cable Length | : | Low Noise Teflon Shielded 5 mtrs with BNC connector |
| Process Connection | : | NPT Male |
| Mounting | : | Immersion or in-line mounting |
Conductivity Sensors / Electrodes MS CD 03
| Specification | ||
| Body | : | SS 316 |
| MOC of Electrode | : | Platinum / Glass |
| Cell Constant | : | 0.1 / 1.0 |
| Operating Temperature | : | 100C |
| Mac Operating Pressure | : | 5 Bar |
| Temp. Compensation | : | Pt-100 ( Optional) |
| Process Connection | : | & BSP Male |
| Cable | : | 5 Meters |
Ozone Amperometric Sensors MS OZ 2
| Type | : | 2 pole Sensor, Gold Cathode, Silver/Silver Halogenid Anode |
| Range | : | 0.00 2.00 ppm |
| Resolution | : | 0.01 ppm |
| pH Range | : | 2 11 pH |
| Temp Range | : | 0-45C |
| Output | : | 4-20 mA |
| No of Electrodes | : | 2 |
| Membrane Cap | : | M20 |
Oxygen Indicating Analyser flame proof / weatherproof 4-20mA output
| Specification | ||
| Display | : | LED |
| Range | : | 0 to 21% |
| Resolution | : | 0.1% |
| Accuracy | : | 2% of FS |
| Response Time | : | 14 2 Seconds |
| Linearity | : | 0.21 0.02 |
| Operating Temperature | : | 5 to 40C |
| Operating Pressure | : | 811hPa to 1216 hPa |
| Operating Humidity Range | : | 10 to 90% RH ( Non condensation) |
| Output | : | 4 to 20 mA |
| Supply | : | 24 VDC |
| Enclosure | : | Flameproof ( Gas Group IIA / IIB |
| Mounting | : | Wall Mounted |
ORP Sensors with Platinum Tip MS ORP 01
| Specification CPVC | ||
| Make | : | MicroSet |
| Model | : | MS ORP 01 |
| Type | : | Combination |
| Range | : | 2000 mV |
| Temp Range | : | 0 to 60C |
| Ref Type | : | Double Junction AgCl |
| Junction Type | : | Ceramic |
| Diameter | : | 12 mm |
| Overall Length | : | 85mm |
| Body | : | Epoxy |
| Pressure | : | 5 Bar |
| Process Connection | : | & 3/4 BSP |
| With integral cable of 5 Meter long with BNC | ||
Mr. Jayesh Ramchandani (MICROSET CONTROLS)
MICROSET CONTROLSReg Add : B 404 Marvel Imperial FP No 260/2 260/3 Narangibaug Road Boat Club Pune Maharashtra 411001 India., Sangamvadi
Share us via
View Contact Number 
