Our Products
Variable Speed Motor Drives
2 Products availableIndustrial Motors
1 Products availableElectrical & Electronic Goods Repair
1 Products availableElectric Control Panels
1 Products availableGeared Motor
1 Products availableUPS
1 Products availableElectric Fittings And Components
1 Products availableAir Conditioner Parts
1 Products availableWe are leaders in the market for providing best range of Dc Shunt Motor, Dc Tachogenerator, IDENTICAL DC MOTORS, DC Motors and COMPOUND DC MOTORS
" MOTCO " make Identical sets of DC Shunt/ Series motors for performing various tests. |
| |||
Shunt wound Motorsare the most widely used as they have a linear characteristic of Voltage & Torque. Shunt motor has more constant and controllable speed over various loads.This type of motor runs practically constant speed, regardless of the load. It is the type generally used in commercial practice and is usually recommended where starting conditions are not usually severs. Speed of the shunt-wound motors may be regulated in two ways: first, by inserting resistance in series with the armature, thus decreasing speed: and second, by inserting resistance in the field circuit, the speed will vary with each change in load: in the latter, the speeds is practically constant for any setting of the controller. This latter is the most generally used for adjustable-speed service, as in the case of machine tools. Series Wound Motorsare used for High starting Torque Applications. Series motor has greater torque capabilitiesThis type of motor speed varies automatically with the load, increasing as the load decreases. Use of series motor is generally limited to case where a heavy power demand is necessary to bring the machine up to speed, as in the case of certain elevator and hoist installations, for steelcars, etc. Series-wound motors should never be used where the motor cab be started without load, since they will race to a dangerous degree.Common uses of the series motor include crane hoists, where large heavy loads will be raised and lowered and bridge and trolley drives on large overhead cranes. The series motor provides the starting torque required for moving large loads. Traction motors used to drive trains are series motors that provide the required torque and horsepower to get massive amounts of weight moving Compound Wound Motorsare used for Mixed Load Applications. The above two desirable characteristics can be found in the same motor by placing both a Series field and Shunt field winding on the same pole. Thus we have, the Compound motor. The Compound motor responds better to heavy load changes than a Shunt motor because of the increased current through the series field coils. This boosts the field strength, providing added torque and speed.A combination of the shunt wound and series wound types combines the characteristics of both. Characteristics may be varied by varying the combination of the two windings. These motors are generally used where severe starting conditions are met and constant speed is required at the same time When comparing the advantages of the series and shunt motors, the series motor has greater torque capabilities while the shunt motor has more constant and controllable speed over various loads. These two desirable characteristics can be found in the same motor by placing both a series field and shunt field winding on the same pole. Thus, we have the compound motor. |