For quick and cost effective repair of cosmetic body work damage. SPEED will handle most of the typically jobs up to 80%. Same repair bay will complete the job on the Speed platform That means a lot of time sawing with out changing location of the car to do e.g. parts out pulling jobs, welding grinding and filler sanding jobs.
Lifts with large size platforms and sturdy structure assuring maximum rigidity and working stability The best solution for a rational workshop: space saving when lift is raised obstacle free floor space when lift is fully lowered. No cross rails or torsion bars between lifting platforms (for maximum accessibility in the working area)
The hydraulic cylinder is located inside the fixed platform and is thus perfectly protected.High-resistant, galvanised and pre-stretched metal cables.Large-diameter pulleys with self-lubricating and maintenance-free bushes.Adjustable platform to accomodate different vehicle tracks and optimised access to vehicle underside.Automatic mechanical back-up safety devices (every 100 mm) with pneumatic release allowing stationary operation with unladen cables.Immediate-triggering safety stud devices in case a cable slackens or fails.Automatic anti-toe trap alarm during final stages of lift descent.Mechanical, electrical and hydraulic safety devices in compliance with the prevailing standard for CE marking.Low-voltage (24V) electrical system with control circuit
The traditional lift for tyre service shops, easy to install both indoor and outdoor. Mobile run up ramps. Minimum height of only 90 mm, for optimum loading of low profiled cars, avoiding contact between underbody and lifting platforms.
Feature2 VERSIONS: Indoor and Outdoor installations.
Two types of column: Master column with main control panel featuring all selection and controls. Slave Column with secondary control panel, featuring lifting and lowering controls and emergency stop button. Large and solid base for maximum stability under load. European Safety Regulations and CE Certified.Available in 4, 6 and 8 Column.
FeaturesAudible alarm during the final lowering phase.
Lifting Equipment - Inspection Scissor Lift Inspection scissor lift with 3 ton capacity - Ideal for In-Ground installation. No cross rails or torsion bars between lifting platforms.
Free floor design wih twin motors. Very low lifting pad with adjustable height. Electro-Mechanical or Electronic synchronization. Tubular structure made of 5 robot welded sections. Main nut and safety nut made of bronze with high resistance to wear, for greater safety. Steel high resistance rolled screws, to provide long life.