Our Products
Weighing Scales & Measuring Tapes
2 Products availableSigns
1 Products availableRulers
1 Products availableLeading Manufacturer, Supplier & Retailer of Axle Weigh Bridges, Foundationless Weigh Bridges, weighing pads and Ultra Slim Weigh Pad.
In axle weigh bridges, there is a small platform ( 2 m x 3 m ) on which axles of the vehicle are weighed one by one. Weight of all the axles is then added to give total weight of the vehicle. This weigh bridge finds application in stone crushers or to weigh less costly materials where economy rather than accuracy is of prime importance. This weigh bridge is an accurate weighing system which can weigh any type of vehicle regardless of its length or the no. of axles it has. When a vehicle moves across the platform at slow speed & front axle stops on it for a moment, the electronics waits for the axle weight to become steady and then catches this weight into memory. It has a light, which goes off when the weight has been captured so that the driver knows when to move to the next axle. After that, each axle is weighted and its weight is stored in memory to give the total weight of the vehicle.
Features Of Intelligent TerminalAdvanced micro- controller based technology
In-buit line filter
Auto zero maintenance
4 line 40 character lcd display with back light
Memeory of 5000 tranactions
13 mm red led display, 25 or 50 optionalparallel display
Rs 232-c port for computer interface
Conventional weighbridges have heavy rigid platforms and require costly & time-consuming civil foundation. This makes shifting of the weighbridge very expensive as trailers / open truck is required to transport it and again civil foundation has to be built at the new site. Also, time taken & labor involved for dismantlingand re-commissioning is enormous and hence adds to the cost of shifting tremendously.
Mild steel construction | |
Designed for rough & tough industrial applications | |
Each pad contains load cells which can be replaced individually if required | |
Can be placed on a leveled tar or concrete road | |
A set of four pads can be used as an economical alternative to regular weighbridge. | |
Ramp height - 100 - 180 mm depending on capacity & size | |
Portable enough. Can be shifted easily | |
Fully calibrated and ready to use. Installation time takes less than one hour. |
individual calibration for each pad. A portable data case including rechargeable battery, dot matrix roll printer, and LCD digital readout can be supplied for installations which require frequent shifting. The system is factory calibrated and ready to use when you get it. It can easily be setup by a single individual in minutes and is very easy to use and transport.
Dynamic Accuracy: + / - 1% of full scale with leveling track
Graduation- 10 kg
Ground level Requirement- concrete or asphalt surface, level within 1/8" over entire supported area
Temperature range -20C to 60C
Optional leveling track of High density plastic / rubber compound
The ADT500 system is an on-board weighing system that can be used for charging by weight at the point of loading/unloading. It comprises of 4 to 6 durable load cells, an inclinometer, indicator and printer. The system allows for corner and compensation of the truck tilting up to 10. Our advanced loadcells together with the chassis inclinometer produce weighing accuracies better than 20 kg in 15, 000 kg.