Material of gas-conducting parts PVDF, PTFE, PVC, EPDM, FPM, Novoprene Power supply Input voltage 230 V (207...250 V) AC, 50 Hz or 60 Hz ± 2 Hz 115 V (100...135 V) AC, 50 Hz or 60 Hz ± 2 Hz Power consumption during operation Diaphragm pump approx. 50 VA, metering pump approx. 3more...
We are offering gas shielded arc welding wires. Sunmig s-6 is copper coated manganese silicon bearing wire for gmaw using co2 or 80% ar, 20% co2 mixtures for shielding. Sunmig s-6 is designed for all positional welding of sheet metal, carbon steels & low alloy steels including stmore...
we are offering gas shielded stainless steel arc welding wires. sunmig 308l is suitable for welding of the 188 types 302, 304 & 304l steels. in addition to possessing good resistance to general corrosion, the low carbon grade ensure resistance against intergranular corrosion. themore...
Steel Metal Disk Steel discs are very important. The disc acts timing device to allow the Exothermic Weld Powder to heat to proper temperature. Steel Disk is designed to contain the exothermic reaction to the upper crucible of a mold until the reaction is complete and ready to Wemore...
For most connections involving lugs, cable or rectangular bus, exothermic handle clamps are used. These will fit 90% of all standard exothermic molds. Normally we recommend One Handle for every two moulds.These are manufactured by the professionals using high quality raw materialmore...
Graphite absorbs moisture from weather. So there is a need for propane torch to dry out the inside of the mould thoroughly on both sides, therefore heating the mold to approximately 250 degrees Fahrenheit We recommend using one Flame torch for Every 100 Joint and than use the refmore...
Feature : Accuracy Durable, Auto Reverse, Corrosion Resistance
Surface Finishing : Polished
Thickness : 0-5mm
Material : Metal
Application : Industrial Use
The weld neck flange is normally referred to as " high Hub" flange. It is designed to transfer stresses to the pipe, thereby reducing high stress concentrations at the base of the flange. The pressure tappings are provided through the flangewhich arte at a distance of 1" from themore...