We carry out the quality examinations only under the vigil supervision of the quality auditors. The rolling mill stand we provide is available in the weight 200 tons. As we promise to offer quality approved products to the clients, we make use of only high-grade raw materiamore...
We are offering ugi mill stand. Ugi engineering works private limited manufactures mill stand of conventional design as well as housing less stand of wire rodstmtlight section medium section mills. Salient features of ugi stand • compact and simple design to ensure quick rolmore...
3 Hi / 2 Hi mill stands are of steel / cast iron machined accurately and fitted with linear pads of high grade steel to prevent the housing from wear & tear. Â The mill Sit tighter on the Bed plate after proper spacing along with rest bars. Â Roll bearing Chocks are cast out of smore...
We are Offering 3 Hi/2 Hi Mill Stands are of Steel/cast Iron Machined Accurately and Fitted with Linear Pads of High Grade Steel to Prevent the Housing from Wear & Tear. the Mill Housing in Tighter On the Bed Plate After Proper Spacing Along with Rest Bars. roll Bearing Chocks armore...
Rest assured on us for the superfast deliveries that we carry out in the stipulated time span. We lay great stress on packaging and make sure the materials used for packs are industrial grade and superior. Each pack is labeled properly and it carries essential product details. &nmore...
Our hydraulic mill roll stand is featured by low maintenance, reduced wastage and user friendliness which in the long run is cost effective & economical. We can also produce them according to customers demands and requirements.more...
Our hydraulic mill roll stand is featured by low maintenance, reduced wastage and user friendliness which in the long run is cost effective & economical. We can also produce them according to customers demands and requirements. more...
UGI Mill stand has Compact and simple design to ensure quick roll change, easy maintenance and to avoid major down time. Heavy duty Housing will be steel fabricated duly stress relieved with Single lubrication point is for all mill bearings and wear-out liner for enhance increasemore...
The stand design incorporates many features and vital for the best operation and production of quality rod. The roll roll holder is of a design which allows the carbide rolls to be mounted on the holders, without introduction of hoop stresses into the carbide, with a consequentiamore...
All mill stands are built heavy to with stand high rolling load. Roll necks are with antifriction bearings. Close control set up of screw down & axial shift of rolls are provided to prevent roll skewing during rolling. Finishing Mills are 4-High design to give 8 gage accuracy. Edmore...