KND Steel Syndicate

Naraina, Delhi

Our Twin Ferrule compression tube fittings accessories have been carefully manufactured to withstand the demands made of high performance tube fittings, such as high pressure, vacuum, vibration, temperature and impulse. The compression tube fittings are manufactured to exacting tolerances using the most modern and advanced computerised automation.

Our compression tube fittings are composed of four parts: Body, Front Ferrule, Back Ferrule, Nut.

This compression tube fitting is a mechanism used both to seal and to grip tubing. The mechanical advantage and geometry of this kind of fitting produces a leak-tight assembly. To assemble, simply insert the tube into the complete assembly until the tube bottoms-out against the shoulder of the fitting body. The two ferrules are driven forward between the nut and fitting body using the mechanical force created by rotating the nut clockwise. The back ferrule is driven against the tapered rear of the front ferrule and the front ferrule is driven by force into the tapered mouth of the body.

The rear ferrule is swaged radially inwards on the tube while lifting the front ferrule out to form a full-faced seal on the tapered surface of the body. The 1 1/4 turn of the nut from the hand tight position assures consistent drive of the sealing members. This ensures an effective seal against high pressure as well as ultra clean conditions.

Product description:knd steel syndicate serves a wide range of the steel industry. Our cold rolled carbon steel strips and coils are fit for demanding automobile & industrial applications. We cater to auto component manufacturers, electrical switchgears, cutting tools, pen clip, hair clip, hanger clip, chain link manufacturers among others. Available strip & coil grades - c-40 en-8 mc 11c-55 en-9 mc 12c-60 en-43 dc-80 en-42 jc-98 en-44 d50crv4 en-47 strip & coil sizes - width from 5 mm to 400 mm thickness range - 0.10 mm to 5.0 mm hardness range -fully annealed, annealed, as rolled surface finish -bright mirror finish

Specifications

• Pressure: 125 WSP
• End Connection: Threaded
• Application: Steam

HEX COUPLING

ADAPTER

FEMALE TEE

Cylinder valve outlet connections tend to be of two main types: internal accepting a bull nose or external using flat-seated with a washer. Within these types there are variations of thread type, size and direction as well as outside diameter.

Regulator inlet connections are normally available in brass or stainless steel. Some fittings may not be available in brass depending on the properties of the gas they are intended to be used with. A good guideline is to follow the cylinder valve material, if the cylinder valve is brass, brass or stainless regulators and fittings should be acceptable, if the cylinder valve is stainless steel, brass regulators and fittings should not be used.