Our Products
Laboratory Shakers
2 Products availableChemical Machinery & Plant
1 Products availableAutoclaves
1 Products availableRack
1 Products availableFreezers
1 Products availableWe offer the best product range of KEMI Blood Bag Shaker and KEMI Plasma Thawing Bath.
Double wall construction, inside of AluS.S and outside of M.S beautifully powder coated with a front door having glass window to inspect the samples inside the chamber. These chambers are designed for environmental testing of production samples where both temperature and humidity are to be controlled. Temperature can be controlled from 5°C to 60°C with an accuracy of +- 1°C. Temperature and Humidity controlled by Digital Temperature Controller Cum Indicator-LED [Dry & Wet Bulb Method] from 40% to 95% with sensitivity of +-3%. Supplied with relative Humidity Chart but without hygrometer. Power supply -220230 V.
Oscillating platform is made up of SS, been oscillated up and down with approximate 30 mm displacement at the end.
Made with heavy gauge MS tubular pipe with thick gauge MS frame duly powder coated OR Tubular Aluminium Pipe with Aluminum frame having rack size of 48'' X 21''. Height between each rack is 15''. Each rack is fitted with two nos of fluorescent tube and one U.V Germicidal tube. Each tube has separate ONOFF switch. 0-24 hours weekly Cyclic Timer also equipped with the unit for illumination purpose [for controlling all the fluorescent tubes inside the racks]. Electronic chokes are fitted on a separate side control panel box. Complete with 15 Amps cord wire plug to work on 230 VAC.
Made of outer MS sheet duly powder coated and inner made of SS sheet .The temp is maintained by a programmable micro processor controller, temp range + 37C to 56C, +/-0.5C with audio visual alarm for low & high temp. Mechanism of thawing is by pumping with high capacity pump and maintain temp of water by heater with sealed sensor dipped directly in water. Removable type S.S tray with partition for holding 12 bags. Foldable lid with outer S.S and inner plastic with two handles. The whole unit is to work on 230V, 50Hz.
KPTB-1 | 470x290x260mm | 40Ltr | 12-15 |
Stabilizer can be supplied at an extra cost on request.
NB: Non-use of stabilizer will render the warranty of the equipment invalid.
It is table top front loading autoclave, double walled out, outer M.S powder coated inner 30 grade S.S. All joints are argon welded. Door is amde up of heavy gauge S.S shet and using high quality silicon gasket used with ISI marked immersion heater 1.5 KW in 230240V Features: Fully automatic microprocessor based control. Digital timer both for wet and dry cycle. Alarm after the total command is completed. Cyclic timer 10 to 15 minutes. Temp range 121oC - 134oC Unit is supplies with 2 Nos. S.S trays with tray stand.
Double wall, inside made of S.S and outside of M.S duly powder coated with a Temperature range ambient + 5°C to 80°C, Temp is controlled by Micro Processor based Digital Temperature Controller Cum Indicator [LED]with an accuracy of+-0.5°C and with shaking speed of oscillating tray is 40 to 140RPM. Supplied with SS tray having Lotus Clamps. Driven by geared motor and supplied without thermometer.
The technical features are same as Horizontal Laminar Air Flow Cabinet but the air flow passing through the Hepa filter (Deep Pleat)"CLASS 100" [with the help of 15HP motor-1440Rpm] in vertical way and the contaminated air is going through the exhaust duct [14 HP motor-2880 RPM] fitted on the back bottom of the unit. The instrument is made of marine plywood with exterior epoxy water and chemical proof painted with putty finishmica.
-Laminar Flow principle involves double filtration of air. Atmospheric air is drawn through pre-filter and is made to pass through highly effective HEPA (High Efficiency particular Air)deep pleat filter having efficiency rating as high as 99.99% with cold DOP and 99.97% with hot DOP, thus retaining all air-borne particles of size 0.3 micron and larger. Double filtered air blows in laminar flow through the worktable at designed velocity of 90 ftmin +-20%. Noise level: - Less than 65 db at work area, and Vibration:-0. 00005 cm of work table.
These shakers are ideal for mixing and development of cultures, chemicals and pathological work etc.The unit is fabricating from heavy mild steel duly powder coated with continuous duty motor and controllable shaking speed upto 250RPM having different sizes of platforms with rubber disks for holding flasks.
It is specially designed to maintain donor platelets in an even suspension throughout blood plasma. Platelet Agitator agitates at a fixed speed of 70-80 strokes per minute. Maximum 32 standard blood bags can be accommodated.
It is an eco friendly CFC free refrigerant and specially designed for storing blood bags and other specific medical products like vaccines, cultures, reagents, etc., in fixed temperature of 40C to 60C with an accuracy of +/- 10C. Made of double walled -Inner chamber stainless steel and outer mild steel beautifully powder coated.
2. Outer door is provided with magnetic gasket, which keeps the door sealed against
warmairand moisture
Optionals
1.Recorder -7 days Circular chart Recorder - Ink type and Inkless type2.Micro Processor Temperature controller to take print out of the temp reading in regular intervals.3.Automatic Voltage Stabilizer 1 Kva [For KBR- 40& 70]Automatic Voltage Stabilizer 3 Kva [For KBR - 120&144]
Note: Outer body SS 304 quality can be fabricated on extra cost.
Model No. | Capacity | Volume (Approx.) | Inner Chamber W x D x H [ mm] | No. of shelves |
---|---|---|---|---|
KBR-40 | 60 Blood Bags | 135 Ltr | 450 x440 x 1010 | 4 |
KBR-70 | 144 Blood Bags | 250 Ltr | 520 x 490 x 1010 | 4 |
KBR-120 | 244 Blood Bags | 375 Ltr | 600 x 520 x 1200 | 4 |
KBR-144 | 288 Blood Bags | 620 Ltr | 780 x 680 x 1200 | 4 |