Our Products
Adapter
1 Products availableScaffold Couplers
1 Products availableScaffolding Jack
1 Products availableWe offer a complete product range of Drop Forged Double Coupler, Drop Forged Swivel Coupler, Drop Forged Putlog Coupler, Pressed Double Coupler and Double Swivel Coupler
Forged type Double Couplers are the important load bearing components and provide the maximum strength when connecting two scaffold tubes at right angles. Suitable for any tube having an outside diameter of 48.3mm
Forged type Swivel Couplers can connect two scaffold tube at any angle for ledger, facade or similar bracing. These are important structural components and must be load-bearing.
Putlog Coupler is used to fasten transom tubes to ledger tubes in the same way as the conventional fittings, but incorporates two flaps to give a flush top surface to the tube. The flap is manufactured from a high quality steel drop-forging. It is not a load bearing coupler.
Double Coupler connect two scaffold tubes at right angles. These are critical components in the scaffold structure and must be load bearing to resist both slip and distortion. The design is based on a strong one piece body with flaps and T-bolts hat can be removed for maintenance or replacement. |
Swivel Couplers connect two scaffold tubes at any angle to provide ledger, facade, or similar bracing. These are also key components in he structure and must also be load bearing. The body is firmly riveted to permit rotation and still ensures the minimum of further movement, for maximum rigidity. Again, the T-bolts can be removed for maintenance.
There is often a requirement to fasten scaffold tubes to girders and other steel sections and it demnds a specialised fitting with a high degree of a versatility. The gravlock Girder Coupler has been specifically designed for attachment to either horizontal or vertical flanges, and will accommodate up to 43mm (13/4") in depth. In erection , the gravlock Coupler is highly effective, as it enables the fittings to be bolted to the girder first, leaving both hand free to present and secure the tube. As the tube s not compressed against the girder it is not distorted by the fastening process. Gravlock Couplers must be used in pairs.
Sleeve Coupler join two scaffold tubes tubes externally end to end. A steel divider located centrally ensures equal insertion of each tube. They can be employed where tension joints are required and therefore are particularly useful for long bracing and ledger tubes. |