Furnace Oil is a fraction obtained from petroleum distillation, either as a distillate or a residue. Broadly speaking fuel oil is any liquid petroleum product that is burned in a furnace or boiler for the generation of heat or used in an engine for the generation of power, except oils having a flash point of approximately 40 °C (104 °F) and oils burned in cotton or wool-wick burners. In this sense, diesel is a type of fuel oil. Fuel oil is made of long hydrocarbon chains, particularly alkaline, cyclo-alkaline and aromatics. The term fuel oil is also used in a stricter sense to refer only to the heaviest commercial fuel that can be obtained from crude oil i.e. heavier than gasoline and naphtha.  Furnace Oil is a residual fuel (motor spirit / gasoline, high speed diesel and kerosene are distillate fuels). It is a dark, viscous liquid at room temperature. It is a complex mix of hydrocarbons with carbon atoms ranging mainly from 20 to 55. It is produced by blending residues from various refinery processing units and diluting with middle distillates.   SPECIFICATION   Furnace oil in the current marketing range meets Bureau of Indian Standards Specification IS : 1593 - 1982 for fuel oils, grade MV2.   VISCOSITY   Viscosity is the most important characteristic in the furnace oil specification. It influences the degree of pre-heat required for handling, storage and satisfactory atomization. If the oil is too viscous it may become difficult to pump, burner may be hard to light and operation may be erratic. Poor atomization may result in the carbon deposits on the burner tips or on the walls. The upper viscosity limit for  furnace oil  is such that it can be handled without heating in the storage tank is excepting under server cold conditions. Pre-heating is necessary for proper atomization.        

Light Diesel Oil falls under class C category fuel having flash point above 66 O C. It is a blend of distillate components and a small amount of residual components. It is marketed under BIS 1460-2000 specification for Diesel fuels. We deals in Brand like Castrol, Hindustan Petroleum (HP), Indian Oil Corporation (IOC), Gulf, Veedol LDO is used in lower RPM engines. It is used in Lift irrigation pump sets, DG Sets and as a fuel in certain boilers and furnaces.       SAFETY INFORMATION Reactivity Data - Chemically stable and incompatible with strong oxidizers. Does not React vigorously with common materials but may react with oxidizing agents Health Hazard Data - Routes of entry may be through inhalation/ ingestion/ skin/ eye.   EFFECTS OF EXPOSURE / SYMPTOMS Inhalation causes dizziness and headache.  Ingestion may lead to nausea vomiting, irritation of mouth and gastro-intestinal effects likely. Potentially fatal chemical pneumonitis. On Skin and eye contact , irritation will remove natural fats from skin. Prolonged or repeated contact should be avoided, Otherwise skin chapping or cracking or possible contact of dermatitis may result. Dry skin, erythema oil acne and oil folliculitis and warty growth may occur which may become skin cancer subsequently on excessive repeated exposure.   EMERGENCY TREATMENT Inhalation - Remove victim to fresh air. Give artificial respiration if necessary. If unconscious but breathing, place in recovery (Unconscious) position and give external cardiac massage if necessary. Ingestion - Do not induce vomiting. Remove contaminated clothing. Wash all affected skin thoroughly with soap and water. Eyes – Irrigate eyes with copious amounts of water. Administration of medical paraffin may reduce absorption through digestive tract. Gastric lavage should be done only after endo tracheal intubation in view of respiration which may cause serious chemical pnemonitis for which antibiotic and cortico-steroid therapy may be indicated.    

Light Diesel Oil falls under class C category fuel having flash point above 66 O C. It is a blend of distillate components and a small amount of residual components. It is marketed under BIS 1460-2000 specification for Diesel fuels. We deals in Brand like Castrol, Hindustan Petroleum (HP), Indian Oil Corporation (IOC), Gulf, Veedol LDO is used in lower RPM engines. It is used in Lift irrigation pump sets, DG Sets and as a fuel in certain boilers and furnaces.       SAFETY INFORMATION Reactivity Data - Chemically stable and incompatible with strong oxidizers. Does not React vigorously with common materials but may react with oxidizing agents Health Hazard Data - Routes of entry may be through inhalation/ ingestion/ skin/ eye.   EFFECTS OF EXPOSURE / SYMPTOMS Inhalation causes dizziness and headache.  Ingestion may lead to nausea vomiting, irritation of mouth and gastro-intestinal effects likely. Potentially fatal chemical pneumonitis. On Skin and eye contact , irritation will remove natural fats from skin. Prolonged or repeated contact should be avoided, Otherwise skin chapping or cracking or possible contact of dermatitis may result. Dry skin, erythema oil acne and oil folliculitis and warty growth may occur which may become skin cancer subsequently on excessive repeated exposure.   EMERGENCY TREATMENT Inhalation - Remove victim to fresh air. Give artificial respiration if necessary. If unconscious but breathing, place in recovery (Unconscious) position and give external cardiac massage if necessary. Ingestion - Do not induce vomiting. Remove contaminated clothing. Wash all affected skin thoroughly with soap and water. Eyes – Irrigate eyes with copious amounts of water. Administration of medical paraffin may reduce absorption through digestive tract. Gastric lavage should be done only after endo tracheal intubation in view of respiration which may cause serious chemical pnemonitis for which antibiotic and cortico-steroid therapy may be indicated.    

Furnace Oil is a fraction obtained from petroleum distillation, either as a distillate or a residue. Broadly speaking fuel oil is any liquid petroleum product that is burned in a furnace or boiler for the generation of heat or used in an engine for the generation of power, except oils having a flash point of approximately 40 °C (104 °F) and oils burned in cotton or wool-wick burners. In this sense, diesel is a type of fuel oil. Fuel oil is made of long hydrocarbon chains, particularly alkaline, cyclo-alkaline and aromatics. The term fuel oil is also used in a stricter sense to refer only to the heaviest commercial fuel that can be obtained from crude oil i.e. heavier than gasoline and naphtha.  Furnace Oil is a residual fuel (motor spirit / gasoline, high speed diesel and kerosene are distillate fuels). It is a dark, viscous liquid at room temperature. It is a complex mix of hydrocarbons with carbon atoms ranging mainly from 20 to 55. It is produced by blending residues from various refinery processing units and diluting with middle distillates.   SPECIFICATION   Furnace oil in the current marketing range meets Bureau of Indian Standards Specification IS : 1593 - 1982 for fuel oils, grade MV2.   VISCOSITY   Viscosity is the most important characteristic in the furnace oil specification. It influences the degree of pre-heat required for handling, storage and satisfactory atomization. If the oil is too viscous it may become difficult to pump, burner may be hard to light and operation may be erratic. Poor atomization may result in the carbon deposits on the burner tips or on the walls. The upper viscosity limit for  furnace oil  is such that it can be handled without heating in the storage tank is excepting under server cold conditions. Pre-heating is necessary for proper atomization.