jai suriya industries

Tiruvottiyur, Chennai, Tamil Nadu

Galvanized steel scaffolding planks and battens are lightweight non-slip working surface, which can be used with omega transoms. We are one of the dominant manufactures and suppliers of Scaffolds-steel planks. We use all modern techniques in the manufacturing of our world class products. We proffer unique and unparalleled products at acceptable price.

Joint Pin-Provides end to end connection of scaffold tubes. Operates by being inserted internally and expands to apply grip against the inner walls of the tubes. The fittings are designed only for compression joints, and should not be used where tension can be developed in the tubes.

steel scaffolding planks and battens are lightweight non-slip working surface, which can be used with omega transoms. We are one of the dominant manufactures and suppliers of Scaffolds-steel planks. We use all modern techniques in the manufacturing of our world class products. We proffer unique and unparalleled products at acceptable price.

The Return Transom is used at the end of a scaffold run where it meets another scaffold running at right angles to it. The U-shaped return section of the transom hooks over the ledger of the adjacent scaffold, closing off the gap between the two scaffold.

SIE water stopper is compatible with 17mm tie rods, for achieving water tight ties.Water stoppers are made from high quality casting and have a plastic caps at both ends, special feature is an additional surrounding disc for better Anchoring and further security against penetrating water. SIE water stoppers are optimal choice for contractors.

Similar to intermediate transoms, inside board transom is used for providing facility for a single inside board platform.

Wall forms and channel soldiers of 45*45*5mm are manufactured out of M.S slotted angles and 12g M.S sheets to make them rigid and strong. Curvature of wailing tubes are changed to suit profiles of different diameter shells.

Joint Pin-Provides end to end connection of scaffold tubes. Operates by being inserted internally and expands to apply grip against the inner walls of the tubes. The fittings are designed only for compression joints, and should not be used where tension can be developed in the tubes.

Floor Forms and Adjusters Manufactured out of 14 G (2mm Thick) Tested Quality Sheets. Pressed on Four Sides.

Wall Form Economy Panel

• Economy panels are today's most advanced multi-purposed formwork system because: Stiffeners are built into the panel, therefore only two scaffold tube or channel wafers are required for alignment.
• Minimum champs required.
• Rapid assembly with wedge sets
• Can easily be erected by unskilled labour. Accommodates any tie system.
• Durable steel face plate cannot be damaged by vibrators or penetrated by the reinforcing steel.
• The Automatic precision on assembly results in 100% dimensional accuracy of the finished concrete.

APS Unitmade out of two verticals of 40mm NB Tube with scokets of 50 mm NB Tube at the bottom andone horizontal cross bar of 40mm NB Tubes either in heavy or medium class 50mm heavy class sockets; with lugs welded on verticals provides positive support to horizontal 'C' clamp to fix ledger tube for connecting the units.

The Following Models are as below,