International Equipments

Kanjurmarg, Mumbai, Maharashtra

• Highly accurate position control with high range of speed
• Accurate start and stop instanatly using 32 bit microcontroller
• Four line and 20 characters controller with multiple features
• Automatic calculation of modulus @different strains selectable
• Multi unit display in Kg, pound, Newton mm, cm, inch selectable
• Direct display on controller and numeric printout facility
• Safety norms of over load in auto as well as manual mode
• Safety norms of over travel in auto mode.
• Tests preprogramming facility for Tensile, Flexural, Peel, Bond, Compression, Cyclic endurance based on load, travel, time
• Data lock for calibration and master controlled parameters

Micro Controller based Computerised Hydrostatic Pressure Testing as per IS 4984 and IS 4985 to check the creep rupture of pipe when subjected to internal pressure under a specified condition.

or making V notch in the Izod / Charpy samples as per ASTM D 256. Specification: Depth micrometer : Mitutoyo make. Range : 0 25mm with least count of 0.01mm. Cutting angle : 45. Paint : Powder coated. Power : 230 Volts, 50Hz, single phase.

to cut samples having thickness up to 4mm.

Specification:

Temperature zone: Two. Controller: Auto tuned PID controller with temperature range up to 200 deg C having resolution of 0.1 degree centigrade. Clamping Jaws: One fixed and second movable by pneumatic action. Day light: 50 mm. Sealing dimensions: Length 150 mm x Width 20 mm. Mounting: Table top. Power requirement: 230 Volts, 60 Hz, Single phase 15 ampere.

with radial air circulation and auto shut facility. Specification: Size of working chamber : 12 inch X 12 inch X 12 inch*. Material of construction : M.S. Temperature range : Ambient to 250C. Air circulation : Radial fan (It saves power at least 20% by re-circulating the same hot air inside the oven). Timer : Digital presettable with range upto 999 minutes. Paint : Powder coated. Power supply : 230 Volts, 50Hz, single phase.

Tensile testing is a most significant and popular test procedure which is performed in different production verticals to measure the elongation strength and durability of the products. Tensile Testing is also known as Tension Testing, This test shows at what point sample fails when an extensive amount of tensile force is applied to the sample. It helps the engineers to measure the maximum force a material can tolerate to its maximum before it brakes and helps to decide the suitability of the material for a particular application. The tensile test is performed using a high-quality testing machine known as Tensile Tester or Tensile Testing Machine to determine properties of tensile and elongation as per ASTM D - 638 / ASTM D 882 of plastics Eco version. Specification: Load capacity : up to 500 kg*. No. of load cell : One. Cross Travel : Up to 1000mm*. Speed : Variable between 10mm/minute to 500mm/minute. Paint : Powder coated. Power : 230 Volts, 50Hz, single phase. Direct display through microcontroller : Peak load, Area and Tensile strength at peak load.

to determine the effect of relative humidity on sample at various temperatures. Computerised Humidity chamber to determine the effect of relative humidity on sample at various temperatures.

Material of construction : Inner bath: S.SOuter body: M.S Direct display and printout through microcontroller : Set RH, Actual RH, Set temperature and Actual temperature. Graphic display and printout through PC: In addition to the above values, % RH and Temperature Vs Time graph could be obtained by attaching a printer to the PC.