Our Products
Dosing Pumps
1 Products availableHoses, Hose Assemblies & Fittings
1 Products availableMeasuring Instruments & Equipment
1 Products availableLeading Manufacturer, Supplier & Retailer of triple screw pumps, Sanitary Centrifugal Pump, Vane Pumps, Almate Pumps and rotary lobe pumps.
Particulars Min. Max. | Min. | Max. |
Temperature | 30 °C | 130 °C |
Viscosity | 0.8 cSt | 100000 cSt |
Inlet Pressure | 0.8 barg | 6 barg |
Outlet pressure | 0 barg | 16 barg |
Flow-Rate | 5 L/min | 10000 L/min |
VANE PUMPSSLP Series The 1st SEAL LESS rotary positive displacement pump NOT BASED ON MAGNETIC DRIVE Setting a new standard in seal free / Green Benefits ( Up to 25 m3/h 110 GPM) 12 bars (174 psi) Max viscosity: 60, 000cps | |
Performance
|
In addition to the advantages listed above E-Series pumps are available constructed from virgin Polyethylene. Trials based on the sand-slurry method have shown that the abrasion resistance of Polyethylene is 7 times higher than Polypropylene and 1.6 times higher than steel. This high resistance to abrasion makes it the ideal pump for many applications such as pickling baths in the electroplating industry, printing inks, lime slurry, and ceramic mass and glaze in the ceramics industry to name a few.
Almatec also offers conductive plastic E-series pumps. The housings and internals of the conductive version are made of PE or PTFE filled with conductive pigment which always remains below the limits set by the FDA. The pump can be grounded via a connection on the centre housing the eliminating the risk of electrostatic discharge. Conductive pumps in the E-Series are ATEX certified
Wilden offers a range of air operated, high pressure diaphragm pumps amplifies the inlet air pressure to produce 2-3 times the discharge pressure. These pumps are used to pump lubricants, feed a filter press and move viscous liquids.
Wilden and Almatec high pressure pumps do not require costly external boosters or amplifiers to achieve the pressure output needed for your application. Our high-pressure pumps perform a multitude of duties including filtration, chemical sludge transfer and general industrial applications. Wilden and Almatec high-pressure pumps deliver powerful, reliable and flexible solutions to the most challenging of pump applications
Internal rotary gear pump is designed with a simple principle under "Gear within a gear" therefore this oval type gear pump has a high efficiency and capability. When the pump shaft rotates, the fluid enters the pump through inlet and fills the gap between the idler gear and rotor gear. According to rotation of the gears, the fluid is pushed out of the pump discharge. The fluid flows from suction to discharge as figures 1, 2 and 3 illustrate.
|