Indian Steel Traders

Padi, Chennai, Tamil Nadu

We mainly deal with various iron and steel commodities listed in the product section. We export and import the goods from various parts of India and abroad For more than 25 years INDIA STEEL TRADERS has been a name of repute for the supply of quality Industrial Raw Material to its valued customers. It is committed to providing the finest quality products and services and quality performance to every customer, every time.

Steelsheet that has been wound. A slab, once rolled in a hot-strip mill, is more than one-quarter mile long; coils are the most efficient way to storeand transport sheet steel. A rolling mill of several stands of rolls that converts slabs into hot-rolled coils. The hot-strip mill squeezes slabs, which can range in thickness from 2-10 inches, depending on the type ofcontinuous caster, between horizontal rolls with a progressively smaller space between them (while vertical rolls govern the width) to produce a coil of flat-rolled steel about a quarter-inch in thickness and a quarter mile in length.

This is a structural material with cross section of 90 degree angle. The dimension is determined by the length and the thickness of the two sides. If the lenghts of the two sides are equal, it is equal angle, otherwise it is unequal. It is used in all construction activity. The most common length available is between 10m to 12m.

The Coils are uncoiled and cut into a desired width by the process of slitting the coils, and the desired length by uncoiling the coils and cut them into a required length. Coils that is cut to length (CTL) is normally shipped flat-stacked and that is called as Sheets. Sheets are of different types like H.R Sheets, C.R Sheets, G.P Sheets, G.C Sheets, Stainless Steel Sheets etc.

The Coils are uncoiled and cut into a desired width by the process of slitting the coils, and the desired length by uncoiling the coils and cut them into a required length. Coils that is cut to length (CTL) is normally shipped flat-stacked and that is called as Sheets.

It is generally accepted that H.R Rolled Steel which is more then 4mm thick is called as H.R Plates. Plates are normally available in different grades as per the end use like for general fabrication Mild steel is used, Where their is more of wear and tear their Carbon Alloy Steel is used as per the requirements. When there is flow of water or chemicals in the use then Stainless Steel is used.