I Power Technologies Bangalore, Karnataka

We manufacture and supply 11KV HT Metering Cubicles Panels as per ESCOM standards where metering is done in 3 phase 4 wire system employing 3 current transformers and 3 voltage transformers. The panel contains the equipments and components complete with bus bar interconnections, control wiring, designation labels, caution notices, Electricity Board sealing and pad locking facilities wherever required. Required space is provided for entry of H. T. cable from the bottom through detachable gland plates. Bus bars are epoxy encapsulated. Canopy will be provided for outdoor type metering cubicles.   The Current and Potential Transformers used in these panels are Accuracy tested at KPTCL / National Accredited testing laboratory.   Metering Cubical with Load Break Switch 630A, 26.3KA / VCB with Current sensor operated over current & Earth Fault Relay HT HRC fuses of suitable rating (Access to the HT Fuse chamber is possible only after switching OFF the LBS)  The Instrumental Current Transformer (Resin cast) CL:0.5 Confirms to IS:2705. The Insulation Level is 15/35/95kV  The Potential Transformer (Resin cast) CL:0.5 Confirms to IS:3156. The Insulation Level is 15/35/95kV  The Electronic Trivector Meter CL: 0.5  Test Terminal Block 3Ph. 3 Wire Front Connection  Sealing Facility Provided as per EB norms

We are one of the distinguished manufacturers of Motor control centre (MCC) panels. These have the capacity to feed larger loads and are designed as per the client specifications. These are used for controlling, monitoring and regulation of various types of motors. Our manufactured motor control centre (MCC) units comprises equipments like; various types of starters, soft starters, variable frequency drives, solid-state motor controllers with analog / digital metering, feeder circuit breakers, capacitor feeders etc. our products are widely demanded in various industries like chemical refineries, pharmaceuticals, textiles, construction, paper and others.  Features of our MCC Panels are: Duly wired with ACB / MCCB / SFU / DOL / RDOL / STAR-DELTA / ATS Starters. Various designs provided like single/double front, fixed/drawout type, with marshaling terminations Starters are provided with type 2 co-ordination where required Cubicle type extensible on each side Separate bus bar chamber for vertical droppers Can be operating by remote on / off Accommodate various types of cable entries whether top, bottom or a mixture of both, front or rear access, or a hybrid solution using a combination of any form and type. We can also accommodate various special site requirements i.e. the space available and access into the switch room or kiosk whether the limitations be imposed by existing switch rooms / buildings or new builds

• FeaturesCanopy type ceiling.

Feeder Pillars are connected to the distribution board and mainly utilized for housing and street lighting units. The feeder pillars are widely installed for Industrial, Township, Housing Societies, and Lighting applications. Our Distribution Feeder Pillars can be customized for power distribution applications.   Features:-   Can be easily installed and maintained Canopy type ceiling Double-door construction Weather-proof coating Viable for outdoor applications Rubber seal gaskets Tamper proof locks Use of best quality cable clamps for cabling arrangements Cast-iron embellishments for secured installation

We hold competence in manufacturing 11 KV HT Ring Main Unit (RMU) Outdoor Indoor type. This unit finds extensive use in H.T. side. It is marked with switches (Circuit Breakers or Isolators or LBS) of three numbers. This unit finds use for two inputs that may be mechanical or electrical interlock. One outgoing is also provided in this unit to help in heavy load withstanding capacity. On demand, we can also provide this unit with one input that has two outgoings. Apart from these, this unit is also used for purposes such as redundancy feeder. This unit has capacity of 11KV.