Hardcoats India Pvt Ltd

Mira Bhayandar, Thane, Maharashtra

FBTR Pin's End Plug ensures there is uniform heat distribution & balance towards Plug & Tube.

These are the Chrome Oxide, Ceramic, tungsten carbide, stellite, nickel and boron carbide coated sleeve used in Pump Parts, Separators, Decanters.

The RC-2, RC-2A capsules are to be used for encapsulating the radioactivity material.

Latch Extension Tube Seal are used in Ram Assembly of Fuelling Machine Head. These are positive segment seal.

These seals are not completely leak proof, allowing small leakage & acting as lubricant, reducing the friction between the stationary & moving part of the seal.

Shield plug is attached in the plug is attached in the bore of the end fitting to locate the fuel bundles and to provide shielding

These are the Chrome Oxide, Ceramic, tungsten carbide, stellite, nickel and boron carbide coated sleeve used in Pump Parts, Separators, Decanters.

A B C Piston Rod Seal are used in Ram Assembly of Fuelling Machine Head. These are positive segment seal.

These seals are not completely leak proof allowing small leakage & acting as lubricant, reducing the friction between the stationary & moving part of the seal.

The Snout Mechanism Assembly enables the fueling machine head to clamp on to any reactor fuel channel and to seal the connection at high pressure and temperature.

Steam jet ejectors offer a simple, reliable, low-cost way to produce vacuum where no source of power is required other than the motive gas.

Upper & Lower Wedges are used in High Pressure & High Temperature Heavy Water Plant.

Nozzle Dam Assembly used in Steam Generator to plug Primary holes of Inlet and outlet nozzles during maintenance. These are manufactured in Aluminum Alloy, Titanium, etc. maintaining the weight below 40 Kg. The Assembly was Hydro tested at pressure of 6 Kg/cm2 and was found to be leak proof.

Electrical penetration assemblies (shortly EPAs) in a nuclear power plant are installed into the concrete walls of the containment. Their function is to make an electrical connection between inboard and outboard sections of power, instrumentation and control cables.

Inconel X 750 Roll Pins are manufactured from size 3.0 mm to 20 mm conforming to AMS 5542.

Inconel X-750 Compression Springs are manufactured from wire size 0.4 mm to 10 mm conforming to AMS 5699. Compression springs were checked fully for dimension and spring rate and results are within specific requirement of drawings.

This is a precision component in Ram Assembly manufactured from Aluminum Bronze ASTM B 150 grade material. This component is eccentric in shape and the tolerances for eccentricity are 0.025mm and the geometrical tolerances like concentricity and the squareness are within 0.025mm. Various dimensions are controlled within accuracy of 0.005 mm to 0.025 mm.

Shuttle Tube Assembly is used to transfer fuel bundle in Nuclear Power Plant .

3 mtr. Long Tubes are assembled in five different Inner & Outer Diameter Hard Chrome Plated are used in Fuel Handling Machine.