Our Products
Stainless Steel Bars
2 Products availableStainless Steel Sheet
1 Products availableWelded Pipes
1 Products availableSteel Coils
1 Products availableStainless Steel Pipes
1 Products availableThreaded Pipe Fitting
1 Products availablePipe Tees
1 Products availableSteel Products
1 Products availableWires
1 Products availableOur offered Product range includes Ss Flanges, Weld Neck Flanges, Slip-on Flanges and Blind Flanges.
We offer variety of stainless steel flanges that are extensively used in many industrial applications. Our products are well known because of its durability and strength. Our products are work better in various applications and compare to other flanges our SS flanges work longer. We have different specifications and grades of SS flanges.
Below we have mentioned different Stainless steel flanges that we trade:.
WELDING NECK FLANGES are distinguished from other types by their long tapered hub and gentle transition of thickness in the region of the butt weld joining them to the pipe. The long tapered hub provides an important reinforcement of the flange proper from the standpoint of strength and resistance to dishing. The smooth transition from flange thickness to pipe wall thickness effected by the taper is extremely beneficial under conditions of repeated bending, caused by line expansion or other variable forces and produces an endurance strength of welding neck flanged assemblies equivalent to that of a butt welded joint between pipes, which, in practice, is the same as that of unwelded pipe. Thus this type of flange is preferred for every severe service condition, whether this results from high pressure or from sub-zero or elevated temperature, and whether loading conditions are substantially constant or fluctuate between wide limits.
SLIP-ON FLANGES continue to be preferred to welding neck flanges by many users on account of their initially lower cost, the reduced accuracy required in cutting the pipe to length, and the somewhat greater ease of alignment of the assembly; however their final installed cost is probably not much, if any, less than that of welding neck flanges. Their calculated strength under internal pressure is approximately two-thirds that of welding neck flanges, and their life under fatigue is about one-third that of the latter. For these reasons, slip-on flanges are limited to sizes " to 2 " in the 1500 lb standard and are not shown in the 2500lb standard.
BLIND FLANGES are used to blank off the ends of piping, valves and pressure vessel opening. From the standpoint of internal pressure and bolt loading, blind flanges, particularly in the larger sizes, are the most highly stressed of all flange types; however, since the maximum stresses in a blind flange are bending stresses at the center, they can safely be permitted to be higher than in other types of flanges.
Rakhial, Ahmedabad, Gujarat 