Our Products
Generators
1 Products availableMaterial Handling Equipments
1 Products availableMaterial Handling Machines & Systems
1 Products availableElevators
1 Products availableWarehouse Stacker
1 Products availableGrinding Mill
1 Products availableBatteries
1 Products availableMachines And Equipments
1 Products availableWe are leaders in the market for providing best range of FLOW CONTROL GATE, Pendulum Flap Gate, rack & pinion gate, Rod Gate and Slide Gate
Flow control gates have a key role in any kind of plant's operation as it the equipment which gives the feed back about the material passing through the line and controls the flow of the material as per the requirement. Flow control gates are designed & supplied with a provision of 0-100% output flow, which can be set as per the desired output. These types of gates are actuated by motorized/ pneumatic actuator
Pendulum flap gate valves are used as feed or discharge units and as process air sealing systems. They are characterised by a high degree of operational safety, robustness and ease of maintenance.
FRIGATEsupplies Pendulum Flap Gates as doubleor triplependulum gates with either mechanical or hydraulic actuation systems.
Our Rack & Pinion gates are designed to be used in an application in which the flow of materials needs to be shut off, and then restored later. Machined rack & pinion gears allow for easier operation. Nylon rollers are used because they reduce the risk of sparking and they are resistant to rust. Cam Followers are available in lieu of nylon rollers.
Rod gate is generally provided above an apron feeder for controlling the material feed rate. The rod gate has sturdy and rugged construction and is designed to withstand impact load resulting from large sized lumps falling from the storage silo, above.
The Slide Gate is an isolation device and can be supplied in low leak and zero leak designs. The low leak design is primarily used when a small amount of flue gas leakage past the closed gate can be tolerated. Typical leakage can vary from a few percent to less than one percent of flow depending on the type of seal system provided. The zero leak design is used when zero flue gas leakage past the closed slide gate is required. Zero leakage is achieved by pressurizing the seal chamber located around periphery of the closed blade with seal air.
Green Field, Faridabad, Haryana 