Floline Corporation

Kalbadevi, Mumbai, Maharashtra

Ball Valves are of soft seated, Floating Ball, 3 piece design available in both Regular port & Full Port patterns. Ball is seat supported and quarter turn rotates the ball from full open to full close position.
The stem flange, and integral part of the stem, prevents the stem from blowing out from pressure within the body cavity. This feature also allows replacement of stem packing while the valve is under pressure.
One of the most important component in any Ball valve is the Ball itself. The Ball is accurately machined to mirror finish and the exact sphericity to ensure low operation torque and high pressure holding capacity and thus increasing life of the valve.

Optional Features :
* Single piece & two piece design Ball valves. in full port & regular port.* Jacketed construction.* Hard Crome plated Balls.* Extra long extended Ball Valves.

Sizes :15mm to 25mm

Operating Conditions :Max. Operating Pressure : 50 BarMax. Operating Temperature : 4000CMin. Operating Pressure : 0.3 BarMax. Back Pressure : 80%

End Connections :Threaded to BSP / BSPT / NPTSocket Weld to ANSI B 16.11

Installation :Preferably in a horizontal position

The Pennant piston valve (PPV-10) is a linear movement valve in which a stainless steel piston travels between the upper and lower seal ring. These rings are separated by a lantern bushing, which supports the piston and creates a tight seal. When the valve is in the open position, the upper seal ring, in conjunction with the piston, prevents leakage through the stem. In the closed position, the lower seal ring seals the valve passage and provides a tight shutoff.
Known for their extraordinary performance and long life, Piston Valves can handle a variety of media such as steam, thermal fluid, condensate and many other liquids and gasses. They can be used in on/off and throttling applications.

Complete SS construction, AISI 304, (Suitable for blowing out dirt from strainer element)

Completely assembled modules can renew traps easily & in a short span of time without disturbing existing connections. Each module consists of the trap cover with complete float mechanism and air vent fitted in ready to install condition. Cover gasket & name plate are also included which may be needed at the point of installation.

Replacement modules are available for:

Balanced Pressure Thermostatic Steam Trap with inbuilt 'Y' type strainer. Forged steel construction, SS Internals
End conns.:Screwed NPT / BSPT / BSP / SW / FL