Feed Milling Tech

Makarpura, Vadodara, Gujarat

features:-

1. suitable for dry mixing
2. suitable for oil content < 4%
3. homogeneous mixing
4. mixing period 3-5 min (depending upon ground particle size & feed formula)
5. cv < = 7.5%
6. return air chute furnished for internal & external pressure balancing
7. pneumatically operated bom-bay type discharge flap
8. spray nozzles for spraying molasses/oil/water etc.
9. no death corner

features:-

1. suitable for wet mixing
2. suitable for oil content < 10%
3. homogeneous mixing
4. mixing period 2-3 min (depending upon ground particle size & feed formula)
5. cv < = 5%
6. return air chute furnished for internal & external pressure balancing
7. large cleaning door for easy maintenance
8. pneumatically operated bom-bay type discharge flap
9. spray nozzles for spraying molasses/oil/water etc.

Our Hammer mill is basically all purpose grinder which can be used for grinding wide range of feed stuff, Such as Oil Cakes, Extraction meal, Broken rice, Roots, Dry Herbs, Oat, Hulls and maize. The matter to be ground is subjected to the beating action of Hammers until is reduced to the fineness necessary to pass through the sieve. Hammer mill is constructed for high speed continuous grinding. It consists of fabricated body. The grinding chamber is usually formed by a series of steel plates build up on a shaft and separated sufficiently to allow the beaters to be mounted between them upon transverse spindles or pins with pass through the beaters are made from alloy steel (hardened). The rotor is dynamically balanced and mounted on two self aligned bearings. The grinding chamber and the motor are directly coupled and are mounted on a common base frame. Vibration dampers are provided to check any sort of vibrations occurring due to the running of the machine.

Features :-

1. High Capacity
2. Stable Performance
3. Easy to Handle/Maintain
4. Handy Gap Adjusting Mechanism for Course/Fine Grinding
5. Heavy Duty Structure
6. Heavy Bearing Housing
7. M Shaped Beaters for Higher Capacity
8. Air vent/Discharge Provision for Heat Dissipation generated during grinding.
9. Installed with Special Purpose Bearing Designed for Higher RPM/Continuous Working with Grease Lubrication.
10. Pneumatically Operated Mechanism provided at Inlet to remove Iron Particles

Modern technology is used for designing pellet mills for accurate and maximum output, Pellet dia ranges from 2 mm to 25 mm Capacity vary with material characteristics and other factors. Pellet mill supported by our efficient spares service division which guarantees quick supply of quality product of any component form DIES, PRESS ROLL and KNIVES to even the smallest bolt.

Features :-

1. Dynamically balanced capsule assembly.
2. Fixture to remove capsule assembly very easily.
3. Total three cutting knife on machine for better performance & uniform length of Pellet.
4. Sliding winch arrangement on machine for easy removal of die and press roll assembly by which we can reduce die and press roll replacing period.
5. Limit switch to avoid damage on machine in case of chocking.
6. Easy gear type mechanism for gap adjustment between die and press roll.
7. Front chute with door are fabricated from S.S 304 with Pneumatically actuated over flow flap & magnet.
8. Paddle Type Conditioner (Fabricated from S.S. 304) with reasonably long retention time for proper cooking of the material.
9. Variable Pitch Screw Feeder (Fabricated from S.S. 304), with VFD for Flow Control
10. Optional Hydraulic Press for removal of press roll from shaft and bearings.
11. Optional Auto Greasing Mechanism