-
Width (mm)
500
-
Thinckness (mm)
0.4-2.0
-
Speed
60 MPM
The uncoiler drive rotates the coil and brings the leading end in the feeding position. Snubber roll in lowered on the coil and the coil straps are cut. With the operation of peeler table & uncoiler drive, the leading end is fed in the Pinch Roll leveler. The rolls are pressed and the drives of uncoiler & pinch roll take the leading end forward though loop table , vertical guides, measuring roll in to the feed roll. As the Feed roll motor accepts the leading end, the loop table is removed back and the pinch roll drive takes the material in the loop. The leading end is taken ahead of the shear and the end is cut.
