Dynamic Scaffolding & Equipment Co.

Ashutosh Mukherjee Road, Kolkata, West Bengal

(Heavy Duty) Height-M Safe Axial Load-Kg. Prop Closed Extended Closed Extended 0P 1P 2P 3P 4P 1.10 m 1.50 m 2.00 m 2.00 m 3.00 m 1.75 m 2.75 m 3.25 m 3.75 m 4.65 m 3500 kgs. 3200 kgs. 3000 kgs. 2900 kgs. 2300 kgs. 3000 kgs. 2300 kgs. 2200 kgs. 2000 kgs. 1150 kgs. Note : Props must be braced in both directions by tubes and right angle Couplers at approximately 250 mm above Prop Nut when extended beyond 3.6 metres.

Slab shutterings aremanufactured out of 2 mm sheets with pressed flanges and stiffener whichmaintain edges even after considerable number of uses.

Transom, which replace the tubular horizontals offers a form location for Steel battens. Battens are fitted on these specially designed Omega section thus providing a flatandlevel decking.

This component is used either as a base plate at the bottom of a jack to give the necessary spread of load or when the jack is used at the top of the Vertical as headPlate.

The 2-board and 3-board Hop-Up Brackets incorporate the Omega Section for location Battens and attach to the cup joints in order that the Hop-Up Brackets are correctly located each unit includes a FAST LOCK Joint to accept a standardHorizontal.

FASTLOCKcastors lockonto the bottom ofVerticals. The 20cm diameter wheels provide for easy movementof mobilescaffolds.

The adjustable jack provides a method of adjustment which canbeusedat either the top or bottom of a scaffold support structure. Range : 225mm to 650mmAdj.

Being used for work benches are easily and quickly adaptable to a variety of uses including temporary barriers and enclosures.

A range of sizes with non-slip working surface which are used with the Omega Transoms to form the lightest of allworking platforms.

VERTICALS/STANDARDS FAST LOCK Verticals are available to suit any propping or access application economically. The Verticals can be used for support or access as required. The connection point is set at 500/1000 mm Vertical intervals for maximum versatility in use. The lower cups are welded in position, the upper, moveable cups are retained by a fixed stop.

Horizontals are available in a range of Various sizes or can be made to a special length if required. The forged blade end fits in the cup of the Verticals. The simple robust design ensures that Horizontals need no maintenance.