CLAMP SMITH INDIA

NIT, Faridabad, Haryana

Hardened & Tempered, Black Finish

These clamp are widely used for holding press tool and huge casting/dies while machining.

For Machining Center, Milling, Planning, Plano-Milling Etc.

These Clamps are offered in heavier version of the above clamp for clamping heavy blocks. Basic function is same but this is used for clamping from sides of heavy blocks or thicker plates for facing top face in one setting. It is made up of hardened steel & supplied with T-Nuts & Standard Bolts.

For Machining Center, Milling, Shaping, Planning, Jig-Boring Etc.

Used in machining centre, milling, shaping, planning, jig boring, etc. This clamp is useful for job clamping where complete top surface of job is to be machined in one setting & hence can be clamped only from side faces. When serrated front portion is pressed against the job by tightening the front bolt, it gives a downward as well as forward clamping force. It is made up of hardened steel & supplied with hardened T-nuts & Standard Bolts.

For Plastic Injection Moulding & Pressure Die Casting Machines

It is one of the conventional type clamping system made up of S.G.I steel in 500/7 grade. Used in clamping of heavy moulds on plastic injection moulding machines and pressure die casting machines. It comes with forged stopper bolt for the height adjustment and special washer at top of clamp to move the bolt in slot at desired portion. It is used to clamp different sizes of moulds on same machine through it height adjustment feature. It helps save the time of the operator while changing the mould on machine therefore increase the productivity.

For Plastic Injection Moulding & Pressure Die Casting Machines

It is one of the conventional type clamping system made up of S.G.I steel in 500/7 grade. Used in clamping of heavy moulds on plastic injection moulding machines and pressure die casting machines. Its adjustable swivel washer adjust the height automatically with the help of grooved curve on upper portion of clamp. It comes with threaded Stud or T-bolt as suitable.

Hardened & Tempered, Black Finish

U - Clamp are widely used for repetitive clamping applications frequent insertion and removal of part being clamped 

Goose neck clamp are made up of S.G.I Steel in 500/7 grade. Used in holding of press tool and huge castings/dies while machining.

Hardened & Tempered, Black Finish

These Stepped Strap Clamps have teeth at rear matching to that of Step Blocks to be used as support. Unlike other clamps, single piece of step block (not a pair) can be used as support with Stepped Strap Clamp

Hardened & Tempered, Black Finish

Tapped End Clamps are most useful clamps for injection moulding or pressure die casting machine where mould / die is clamped in vertical position, these clamp have adjustable support to adjust the thickness of mould plate.

(Note : T-Bolt or Stud with Nut, Washer etc to be ordered separately.)

For Power Presses, Milling, Drilling, Shaping, Boring Etc.

CLAMP SMITH Universal Strap Clamp is most suitable for die clamping on power presses and a very useful clamp for job clamping on T-slot table of drilling, milling, shaping and other machine tools. It's front portion holds the die and rear portion adjust on the bed of the machine with its design itself. 

Hardened & Tempered, Black Finish

Ideally suited to hold mould on injection moulding machine and die plates on press platen