Bajarang Engineering

Atika Industrial Area, Rajkot, Gujarat

The material used in producing sleeve bearings comprises of  Brass, Copper 65 and Zinc 35.  This enhances the quality and the durability of the product.  

The material used in producing sleeve bearings comprises of  Brass, Copper 65 and Zinc 35.  This enhances the quality and the durability of the product.  

Hydraulic bushings are a special type of bushings. Talking about the first picture, the inner material of the bushing comprises of  Brass and Bronze. The outer material is  Cast Iron.  The second picture is of a hydraulic bushing that is made up of  Brass and Bronze.

Sr. No. Part Number 1 Front Spg. Tata 1612/1210 2 Front Spg. Tata 1612/1210 Groved 3 Rear Spg. Tata 1612/1210 4 Rear Spg. Tata 1612/1210 Groved 5 King Pin Bush Tata 1210 6 King Pin Bush Tata 1312/1612(Old) 7 King Pin Bush Tata 1312/1612(New) 8 Front/Rear Spg. Bush A/L Plain 9 Front/Rear Spg. Bush-A/L 10 King Pin Bush Top A/L 11 King Pin Bush Bottom-A/L 12 Bell Crank-A/L Taurus 2516 13 Bell Crank-A/L Taurus 2516 14 Rear Spg. Bush(Modl.Susp)A/L 2516 Taurus 15 Bell Crack Bush Small -----do---- 16 Bell Crack Bush Big -----do----- 17 Frt.Spg Bush-Jeep 18 Rear Spg. Bush-Jeep 19 Frt. & Rear Spg. Bush -Tata 407 20 King Bush Tata 407 21 King Pin Bush-Tata 608/709 22 Rear Spg. Bush-Tata 608/709 23 King Pin Bush DCM Toyota 24 King Pin Bush-Swaraj Mazda 25 King Pin Bush -Eicher Canter 26 Rear Spring Bush-Eicher Canter 27 Frt. Spring Bush-Tata 2213/2516/1516 28 Rear Spring Bush-Tata 2213/2516/1516 29 Lever Bush Small Tata 2213/2516 30 Lever Bush Big Tata 2213/2516 31 Lever Bush Small O/S Tata 2213/2516 32 Lever Bush Big O/S Tata 2213/2516 33 Lever Bush Small(Reamed Size) 34 Lever Bush Big(Reamed Size) 35 Idler Arm(Centre Pin) Bush-Tata Sumo

These special purpose bushings are manufactured by  Lead Bronze, Copper 76, Lead 15, Tin 7 and Nickel 2

There are various types of SUBMERSIBLE THRUST BEARINGS that are manufactured at our unit, the descriptions of which are explained below: In manufacturing the submersible thrust bearings, two materials are used. The inner material, as seen in both the diagrams, is  Brass.  The upper layer of the bearing is made up of  Asbestos.  Once again, the middle layer of the bearing is made up of  Brass  and the lower layer comprises of  Asbestos.