A V Exports

Kattupakkam, Chennai, Tamil Nadu

Double walled chamber, fully stainless steel. The interspace between the walls is tightly packed with special grade glasswool to eliminate radiation heat loss to the minimum. Pyramid shaped  cover fitted with plastic knob is provided .A drain plug is fitted to drain out used water and easy cleaning of inner chamber. The inner chamber is fitted with immersion type heating element and covered with perforated removable diffuser tray. The Temperature is controlled by thermostat.

Test Sieves offer the highest accuracy and reliability of sieve analysis.  test sieves are designed and manufactured in all respects as per British Standard specification and available in ASTM also.

Sieve Construction : The frame is made of spun stainless steel without any joint in it. A clear rigid design of minimum weight and free from corners where the material could be lodged. Stainless steel SS 304 quality sieve cloth is used for highest performance. An essential feature of the test sieves is that the mesh should be flat and uniform and with permanent tension around the whole circumference. The same is fully observed in  Test Sieves.

Micro Test Sieves : Micro test sieves are available in one piece brass frame of 3, 4 and 6 inch diameter with suitable lid and receiver.

Coarse and Fine Test Sieves : Coarse and fine test sieves 8, 12 and 18 inches in diameter with Lid and receiver assembly are also available.

Wet Washing Sieves : For samples that need to be separated with the help of wet washing. Available in 8 inch diameter by 4 or 8 inch deep with brass frames. A complete range of aperture sizes are available.

There is no national or international specification for wet washing sieves. Sieves will nest with sieves of similar diameter and can be fitted with mesh to any desired specification.

Lids and Receivers : Lids and receiving pans are available in stainless steel or brass in 8 and 12 inch diameter.

We are successfully catering to the international markets of South-East Asia, SAARC Countries, Parts of Europe and Africa.

Techno digitally controlled model bacteriological lab incubator is a double walled chamber with interior made of SS 306 grade sheets & exterior made of cold rolled mild steel sheets finished in epoxy powder coating. Inter space in between walls is tightly packed with glass wool to minimize radiation heat loss. The inner chamber accommodates SS perforated trays at adjustable height. A double walled insulated door mounted on heavy duty hinges & provided with locking arrangements.

Temperature is controlled by a digital temperature controller working in conjunction with PT100 sensor housed in the hot zone.

Air circulating fan assembly driven by suitable motor is incorporated in the unit of maintaining uniform temperature inside the working chamber. Adjustable air ventilator is provided at the top.

Built in front control panel accommodating pilot indicating lamps, ON/OFF switch, digital controller are located at the lower portion or at the right side of the chamber.

OPTIONAL : Microprocessor based digital PID controller with SSR output better ± 1°C accuracy, Digital timer.