APK Engineers

Sector 1, Mumbai, Maharashtra

Ideal heavy-duty burners for bulk frying and general heating requirements of industries andpharmaceuticals, produce powerful torch type blue flames. Available in two capacities.These burners are recommended to be used at a pressure of 320 to 490 gm/cm2(4.5 psig), however, this may be varied by 25%; the heat output being varied accordingly.These burners are also termed as T-22 or T-35 or T-2; Also available in model T50, T78

Ideal heavy-duty burners for bulk frying and general heating requirements of industries andpharmaceuticals, produce powerful torch type blue flames. Available in two capacities.

These burners are recommended to be used at a pressure of 320 to 490 gm/cm2 (4.5 psig), however this may be varied by 25%; the heat output being varied accordingly. Also availablein Model G10

Operating pressure (Variable: 320 to 490 gm/cm2: (4.57 psig)

industries.Produces two linear flames with wider heat distribution, flame stability, increased efficiency and long life ensured by stainless steel corrugated ribbons

Available in four sizes providing different flame lengths.

Specification:Rated operation pressure: 320 to 490 gm/cm2 (4.5 psig) Connection 3/8 BSP Compression inlet.The above burners are available in side loading and bottom loading. Both in two ribbons and single ribbon. Also available in pencil models.

Specification:Rated Operating Pressure :320 to 490 gm/cm2 (4.5 psig)Consumptions at rated inlet pressure:10000Kcal/hConsumption in Kg/hrsKg/h:1.0Inlet Connection:3/8 BSP compression.

The stand shown can be fabricated on request. These burners can be manufactured for piped natural gas or LP gas.

These burners produce long, reducing, lowvelocity flames for an excellent transfer efficiencyin heating dies, moulds, plates, casting and large fabricated components. These burners can bemade in longer length.

Specification:Operation Pressure :30gms/cm2Consumption :450gms/hr to 1000gms/hrConnection :Nozzle to suit 6.4 mm tube or 3/8 BSPM

LP with gas cock as well as MP/HP with needle valves.These burners could bemanufactured for piped natural gasor LP gas. These canteen burners are also available with prefabricated stool type supports.

Ideal for use in Laboratories (Educational Research and Pathological Laboratories).
Most suitable to keep liquids boiling in urns, kettles etc.
Flame can be controlled by a tap installed in the line or installed on the burner
Heavy metal base prevents toppling.
Brass burner tube warrants long life. Also available in stainless steel tube and base.
Attractive electroplated finish prevents corrosion due to fumes.
Available in two sizes.

Made as per customers specification in GI and SS braiding with rubber hose and end fitting in brass or MS plated.