Our Products
Road Safety & Traffic Products
2 Products availableBollards
1 Products availablePen, Pencil & Writing Instruments
1 Products availableSolar Products
1 Products availableAdhesives
1 Products availableOur Complete range of products are Railway Sign Board, Solar Road Stud, Solar Traffic Blinker, Reflective Safety Vest and traffic delineator.
These traffic safety cones are made of special pvc material making them highly flexible and durable. If avechile hits a cone, it does not get damaged and comes to its original state. A high reflective sleeve/ sheeting is fixed on it for better vision at night and bad weather conditions. it also has provision for fixing of plastic chain or caution tape. These are also available with heavy weight base fixed at the bottom, due to which it does not fly-off with fast traffic or winds.
Applications
Typically placed along the road, Junction Entrance or curved road to roadway motorists at an effective distance, super bright LEDs emit a vibrant flashing light to guide motorists and can be seen clearly approx 500 meters. This greatly improves visibility under bad weather conditions, especially at night, rainy or foggy conditions.
made of special strong flexible UV protected ply-urethane mateiral. It reduces road accidents by providing an davnce warning. Its excellent rebound-ability quickly restores its original state without any damage to the vechile as well as spring post.
Applications
Designed to provide enhanced, Dependable road guidance to motorists in bad weather conditions. Much Better than glass beads markers, these are visible from long distances. These are installed with Special hot Melt Bitumen Adhesive avoiding nails etc. Which can have s harmful effect on the road.
Introducing new range of solar energy / solar powered to bring safety on the road to save lives of human beings as well as save electricity.
The right choice for marker application is the hot bit marker adhesive. hot bit hot-applied bituminous marker adhesive is a hot applied bitumious material which, when properly used and applied, bonds markers and reflectors to both asphalt and concrete pavement surfaces. the adhesive is supplied as an say to use single component material which is easily melted and poured or pumped onto pavement surfaces. since it is a hot melt composition . the adhesive sets up on cooling and is ready for traffic in almost 5 minutes. heating can be performed in either directly or indirectly heating melting units. the adhesive contains no rubber polymers which can degrade at application temperature.
Designed for continuous enhanced road guidance along concrete barriers, centre round about & metal guards. These provide night time visibility at locations where normal sign boards cannot be installed. These LDS are fabricated using micro prismatic reflective sheeting & provide superior reflectivity at wider angles.
LDS is intended for the linear reflectorization of concrete Barriers & Metal Guardrails. It provides retroreflection across a very wide range of entrance & observation angles.
ApplicationsHighway clover Leaf Exit Curves concrete barriers metal guard rails tunnel walls gap in verge bridge guard rails approach to bridges centre round about.
Features
Note:-
Latest Advanced Technology in Safety Enhancing. Typically placed along the road, Junction Entrance or curved road to roadway motorists at an effective distance, super bright LEDs emit a vibrant flashing light to guide motorists and can be seen clearly approx 500 meters. This greatly improves visibility under bad weather conditions, especially at night, rainy or foggy conditions.