Nagpur, Maharashtra, India
Our Products
AGNEE manufactures Right Angle straight and Spiral Bevel Gears as per following specifications:
Spiral Bevel gear teeth cut On Gleason no 16 spiral bevel gear generators
Generally in Case Hardening steel, Hardened Tempered and Lapped.
but also in other Alloy Steel, Case Hardened Steels, Mild Steel, Stainless Steel, Induction hardened, Cast Iron, or as specified
for Automobiles and Industries
Custom made as per Specifications, Drawing or Sample
Teeth Size from 1 Module/10 D.P. to 10 Module/2.5 D.P.
Outer Diameter from 24 mm/1 to 300 mm/12
Face Widths upto 250 mm/10
Required information for quotation:Material of Construction steel, hardening and tempering required etcTeeth Specification pitch, angleOuter DiameterFace AngleBore sizeKey way sizeHub sizeAny other requirement
Where two axles cross at point and engage by means of a pair of conical gears, the gears themselves are referred to as bevel gears. These gears enable a change in the axes of rotation of the respective shafts, commonly 90. A set of four bevel gears in a square make a differential gear, which can transmit power to two axles spinning at different speeds, such as those on a cornering automobile.
There are four basic types of bevel gears-
Straight bevel gears: These gears have a conical pitch surface and straight teeth tapering towards an apex
Zero bevel gears: This is similar to a bevel gear except the teeth are curved. In essence, Zero Bevel Gears are Spiral Bevel Gears with a spiral angle of zero
Spiral bevel gears: The teeth are curved teeth at an angle allowing too contact to be gradual and smooth
Hypoid bevel gears: These gears are similar to spiral bevel except that the pitch surfaces are hyperboloids rather than cones. Pinion can be offset above or below gear center, thus allowing larger pinion diameter, and longer longer life and smoother mesh, with additional ratios e.g., 6:1, 8:1, 10:1
The design of bevel gears results in thrust forces away from the apex. With the bearing limitations the gears have to be carefully designed to ensure that they are not thrown out of alignment as they are loaded.
Agnee offers you the widest range of standard, non standard and customised worm gearbox and worm gear motor.
Agnee maintains the highest level of standard in manufacturing of worm gears in gearboxes. Right from the design of gearbox, material selection to manufacturing practice of worm gear box and gear motor.
Worm gearboxes are having cast iron gear case, worm shaft is of Alloy Steel, duly hardened and tempered. The worm wheel is made of Chill Cast Phosphorous Bronze.
AGNEE worm gear boxes have liberal ribbing for increasing heat dissipation area, streamlined sump for carrying more oil and fan of ample size which is effective in both side of rotation.
Design Standards:Wherever applicable, British as well as Indian Design standards are used. Worm Shafts conform to case- hardening Alloy Steels, Worm Wheels conform to phosphorous-bronze as per BS 1400, While Gear case conforms to C.I. Grade 20, IS210.
AGNEE Shaft Mounted Speed Reducer (SMSR) is one of the most versatile drives offering the largest ratio range and capable of powers up to 280kW.
Features
