Adinath Extrusion Pvt. Ltd

Jam, Jamnagar, Gujarat

Apart from the good machinability, corrosion resistance and higher strength properties, brass rods have other added benefits over Stainless steel and Aluminum.

Some close tolerance components like cable glands can be as much as 33% cheaper than Aluminum or Stainless Steel. The swarf resulting from the machining of Brass rods will give fine small chips which are easier to clean and it reduces machine tool wear and use of lubrication whereas aluminum gives a constant build up of swarf when machining resulting in faster tool wear. Stainless steel components can be two to five times more expensive than identical items made in brass.

Brass Solid rods are an excellent replacement for plastic tap tops which are constantly susceptible to stress cracking and failure. The ease with which brass can be hot stamped, polished and plated means that modern designs of brass tap tops are available with lifetime expectancy equal to that of the tap.

Adinath produces Brass Extruded Rods in solid forms and in various shapes like Round, Hex and Squares which are available to suit a wide variety of engineering applications.

These bars are available in straight lengths ranging from 4 mm to 75mm Diameter.

Brass Knurling rods manufactured by AEPL are available in different form such as Straight Knurled or Cross Knurled depending upon the customers requirement.These Knurling rods are available in Solid as well as Hollow Forms. Size Range : From 5 mm to 60 mm Straight or Cross Knurled

Available in Leaded Brass as well as Lead Free Brass Grades available : CuZn37 and CuZn40 Coil form : From 2 mm to 10 mm

In designing a component, it is very essential to take the production costs into consideration to keep it as low as possible while maintaining the quality. We, at Adinath, produce Hollow Rods in Round, Hex and Squares shapes which we can offer to our customers to reduce the production costs. Standard shapes of hollow bar are available which often proves to be a more cost-effective choice for the manufacture of hollow components. Although hollow extrusions cost more per unit weight than solid bars, this is frequently offset by the saving in drilling and reduction of swarf. Using modern production techniques the eccentricity of hollows is minimal

Silicon brass are part of the subgroup of high strength brasses. These materials contain less than 20% zinc and less than 6% silicon. The silicon brasses are solid solution strengthened. These silicon brasses are typically chosen because of their high strength and moderately high corrosion resistance. The conductivity of the silicon brasses is much less than that of unalloyed copper. The silicon red brasses are used for valve stems where corrosion and high strength are critical. The wrought silicon red brasses are designated as UNS C69400 through C69710. Included in this category are the silicon red bronzes. These alloys are similar to the silicon red brasses except they contain very low concentrations of zinc.