Our Products
Globe valve (HAMMER, SANT, L & T, RACER, MALA, RMW, WJ NETA, NORMAX)
Aglobe valve, different fromball valve, is a type ofvalveused for regulatingflowin apipeline, consisting of a movable disk-type element and a stationary ring seat in a generallysphericalbody.
Diaphragm valves (or membrane valves) consists of a valve body with two or more ports, a diaphragm, and a "weir or saddle" or seat upon which the diaphragm closes the valve. The valve is constructed from either plastic or metal.
Foot Pedal Valves are used to operate Pneumatic Cylinders. In the absence of electrical supply, manually operated valves such as Foot Pedal Valves are used. The functioning is the same, however, the solenoid coil is replaced by a foot pedal, which controls the movement of the spool inside the valve, thereby allowing the air to pass.
In a direct acting solenoid valve, a coil magnetically opens the valve in a direct action, lifting the shaft and the seat of the valve without depending on outside pressure.
Foot Valves are a form of check valve, installed at the bottom of Pump suction line, inside the wet well. Foot valves are an inexpensive way to prime a single centrifugal pump. Since Foot Valves are continually submerged in the wet well and not readily accessible for inspection or repair, it is important to select a Foot Valve of high quality long wearing construction. Typical materials include PVC or plastic and bronze for foot valves.
A butterfly valve is a valve that isolates or regulates the flow of a fluid. The closing mechanism is a disk that rotates.
Agate valve, also known as asluice valve, is avalvewhich opens by lifting a round or rectangular gate/wedge out of the path of thefluid. The distinct feature of a gate valve is the sealing surfaces between the gate and seats are planar, so gate valves are often used when a straight-line flow of fluid and minimum restriction is desired.
pneumatics valves are used for pneumatics applications. And this type of valves are used in automation, automobiles,
pneumatics is a branch of engineering that makes use of gas or pressurized air.
pneumatic systems used in industry are commonly powered by compressed air or compressed inert gases. A centrally located and electrically powered, compressor power cylinder, air motors and other pneumatic devices, a pneumatic system controlled through manual or automatic solenoid valve is selected when it provides slower cost, more flexible, or safer alternative to electric in dentistry, construction, mining, and other areas
Additional Information:
Payment Terms : L/C, D/A,
Packaging Details : PACKING IN CORRUGATED BOX
Delivery Time : 2 TO 3 DAYS
Roller Lever Valves are used to actuate the movement of Pneumatic Cylinders. In the absence of electrical supply, manually operated valves such as Roller Lever Valves are used. The functioning is the same, however, the solenoid coil is replaced by a Rolling lever, which actuates the movement of air inside the valve, and out to the Cylinder.
A needle valve is a type of valve having a small port and a threaded, needle-shaped plunger. It allows precise regulation of flow, although it is generally only capable of relatively low flow rates.